Worx WX254L Manual de instrucciones descargar pdf (Pagina 10)

1110

2. Move the top Cover back and forth until the desired bit is in

place.

If the bits in the Bit Cartridge need to be replaced, remove

Bit Cartridge by pushing it up from the window underneath.

Replace the bits with the desired bits. Ensure the bits are

properly positioned in the Cartridge and are not protruding

from the back of the Bit Cartridge.

Or, simply pull a bit from the holder, and replace it with the

desired bit. It will load into the Cartridge automatically when

the cover is opened (See Fig. D).

NOTE:

1. Only 1” long, ¼” hex shank bits are compatible with the

screwdriver.

2. If the Cover is not open fully, the Bit Cartridge will get stuck

when taking it out from the tool. Pull the Cover all the way

back.

3. The Cover may not fully close if the Bit Cartridge is not

properly aligned inside. Make sure the Bit Cartridge has

clicked into place when selecting the desired bit to use.

If the Cover cannot properly close, just turn the Cartridge

clockwise or counter-clockwise a little bit and try again.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Worx WX254L Manual de instrucciones Pagina 10